Installation Instructions

 Continue laying planks, one row at a time.
 Pause, check, then recheck the first three rows again to make sure everything is straight and square
without any gaps in the seams. These three rows are the foundation for the rest of your floor.
 Don't forget to use 1/8" spacers along the side and end walls to maintain a 1/8" expansion zone.
 To fit planks around obstacles, make a pattern of the area on paper or cardboard, trace the pattern onto
the plank and cut.
 To fit a partial plank on the last row, first place a loose plank (B) directly over the last whole plank (A)
closest to the wall. Then butt another plank (C) against the wall overlapping plank (B) and mark plank
(B) where it is to be cut (see Il lustration #1). Do not cut on floor, as you may cut through and damage
new planks. Check to see if the fit is acceptable, then click lock the plank (B) into place.
When you are done, remove all spacers along the walls and install moldings over the planks. When
installing the moldings, always fasten them to the wall, not to the plank.
Customer Service
 1-855-472-3567
Low VOC’s - Indoor Air Quality Certified to SCS-EC10.2-2007
Conforms to California Specification 01350 for the school
classroom and private office parameters.