Installation Instructions

6. Measure the distance between posts.
Using a hack saw, cut the Top Rail (H)
and Bottom Rail (L) to this length.
Be sure to cut equally from either end.
7. Affix the 2 Rail Support Blocks (N) to
the Bottom Rail (L) using included
screws (F). These blocks should be
located at equal distances between
the posts. (See Fig 3.)
8. Slide Bottom Rail Brackets (K) over
the Bottom Rail (L). Position the Bottom
Rail between the posts and affix the
brackets to the posts using Screws (F)
and (G). (See Fig 4.)
9. Slide Top Rail Brackets (E) over
the Top Rail (H). Position the Top Rail
between the posts and affix the brackets
to the posts using Screws (F) and (G).
(See Fig 5.)
10. Attach the Vinyl Post Cap (C) using
PVC Glue (See Fig 6.)
11. Snap Post Sleeve Ring (I) over
post at base. (See Fig 7.)
3
Fig. 2Fig. 3
Fig. 2
Fig. 4
Fig. 5
Fig. 6
Fig. 7
F
F
F
F
F
F
F
F
F
B
D
B
H
F
N
G
each
side
x2
G
each
side
x2
C
L
H
L