CLASSIC VINYL STAIR RAILING SKU# 1129016 Installation Instructions
Required Tools: • Drill • 1/8" Metal Drill Bit • Screwdriver • Measuring Tape • Hacksaw • PVC Vinyl Cement (Menards #172-4587) This product is compliant with NBCC, OBC, BOCA, UBC, and SBC building codes Included Post Components: Item Product Name Size Included Rail Components: Qty Item Product Name Size Qty A Steel Post Insert 37.5" High 1 E Top & Bottom Rail 3" x 1.5" x 72" 2 B Vinyl Post Sleeve 4" x 4" x 38" 1 F Screw Length 1.
Installation Tips: • Plan and draw out your railing project, (to scale) with the actual measurements of your deck or balcony with the location of the railings that need to be installed. • It may be necessary to cut the rails to balance the sections properly. Always cut equal lengths from each end of the rails so the spindles are well centered. • If trimming a section is needed, be sure to remove the steel insert before cutting.
Fig. 3 6. Lay the Top & Bottom Rails (E), and both Steel Rail Inserts (H) following the angle of the stairs. Mark the outside intersection of each end where it extends past vinyl post. Using a circular or hack saw, cut approximately 1" inside the mark. (See Fig 3.) E 7. Slide one Steel Rail Insert (H) facing DOWN H Fig. 8 into one of the Rails (E) with the Spindle holes facing UP, this is your Bottom Rail. (See Fig 4.
RECOMMENDED POST MOUNTING AND FASTENING RECOMMANDATIONS DE MONTAGE ET DE FIXATION DU POTEAU RECOMENDACIÓN DE MONTAJE Y DE FIJACIÓN DE LOS POSTES Post Poteau Poste 2.25″ 2.5″ 3.5″ (Octo) Wood Bois Madera 2″ Hex Lag * On Concrete Sur le ciment Distance du bord En cemento 4″ 1/4″ dia. Expansion 3″ Hex Lag * 4″ Distance du bord 2" Distancia al borde 2" #14 (1/4″ dia.) 1/4″ dia. Expansion 3″ Hex Lag * 4″ Distance du bord 3" Distancia al borde 3" Distance from edge 4" 1/4″ dia.
