Installation Instructions

Finish
Step 7. Roll installed tiles to bond to floor. DO NOT wash floor for five days. Replace wall base and
mouldings.
Precautions
 When installing over an existing resilient floor, lay out the installation so the new seams are a
minimum of 6˝ away from the original seams.
 When installing over tile floors, seams should fall in the center of the tile.
 When using tile from two or more cartons, check to be sure all pattern and lot numbers are the
same for proper color match.
 Tile products with directional arrows on the back should be installed with the arrows all pointing in
the same direction.
 Do not wet wash tile for at least five days after installation. This will allow the adhesive under the
tile to dry and prevent excess moisture and cleaning agents from interfering with the adhesive
bond.
 Make sure tiles are butted tightly at all edges to prevent separation.