Installation Instructions

2
Installation Guide | Wall Panels
Estimating Stone Quantities Needed
Panels (flats) and Corners can be used for all installations. Panels
are applied to the flat wall surface and are ordered per piece.
Each piece is one square foot (6” x 24”). Corners are applied to
outside or inside corners and are ordered in square feet. Each
corner comes in two pieces, 6” x 8 “ and 6” x 16 “ with the two-
combined equaling one square foot.
Project Sq. Footage Openings Sq. Footage Adjusted Project Sq. Footage
1. Determine the total project square footage by multiplying
the length by the height of each surface area to be covered
and then deduct the area of all openings such as doors
and windows.
2
Lineal Footage of Corners Sq. Footage of Corners
2. Determine the lineal footage of corner stones needed for the
project by measuring the lineal feet of corner areas
to be covered including. Don’t forget to include any
doorways, indents, notches, etc that will require corners.
3. Determine the square footage of corners required for the
project by multiplying the lineal footage of corner stones by
two. (One lineal foot of corners equals two square feet of
MSTONE corner panels).
Adjusted Project Sq. Footage Corner Sq. Footage Sq. Footage of Panels to Order
4. Subtract the corner square footage from the total project square
footage (point 1). This will give you the square footage of panels
(flats) required. However, some extra quantities of flats is
desirable for best fitting and for cutting and trimming.
5. Add 5-10% extra as a buffer
Doors/
Windows
Estimating Work Sheet
2
10%