Shelf Kit with Pole Assembly Instructions 4029 / 4049 / 4080 Tools Needed: 1/4 in.
SAFETY PRECAUTIONS WARNING • This unit contains small parts which could be a choking hazard for small children. Children should be under adult supervision at all times or serious injury could occur. • Always unload unit prior to moving the unit. The weight of personal belongings can cause the unit to become unstable and either tip or collapse. Serious bodily injury and/or damage to personal belongings may occur. • Do not overload unit.
DESCRIPTION QUANTITY A top shelf 1 B inner hang rod 1 C outer hang rod 1 HARDWARE A B (H1) x 2 side support (H2) x 14 small screw (H3) x 6 long screw C (H4) x 6 wall anchor (H5) x 1 back support (H6) x 2 hang rod bracket Note: You will have extra hardware depending on application.
STEP 1 (H2) (H2) (H1) (H1) (H2) (H4) (H3) Cabinet If securing cabinet to cabinet: (H1) x 2 side support 1. 2. Wall (H2) x 4 small screw Position the side support brackets (H1) so that they align with the top and front edges of the base cabinet. Do not align with front edge of the trim. Secure the side support brackets into place using small screws (H2).
STEP 2 A (H5) Wall (H4) (H5) (H3) (H5) x 1 back support 1. 2. 3. 4. (H3) x 2 long screw (H4) x 2 wall anchor Place the top shelf onto the side support brackets (H1). Center and mark the location of the back support bracket (H5) then remove top shelf. Predrill the bracket hole locations with a 1/4 in. hole. Insert wall anchors (H4) and secure the back support bracket with long screws (H3). Anchors are not required if installing directly into studs.
STEP 3 (H2) (H2) (H2) (H2) x 6 small screw 1. 6 Place the top shelf (A) back into position on the support brackets and secure using small screws (H2).
STEP 4 (H2) (H2) (H6) (H6) (H2) (H6) If securing cabinet to cabinet: Cabinet (H6) x 2 hang rod bracket 1. (H3) Wall (H4) (H6) (H2) x 4 small screw Position the hang rod brackets (H6) into the desired position (approx. 2-1/8 in from top edge and 1-1/4 in from front edge) and secure using small screws. If securing cabinet to wall: (H6) x 2 hang rod bracket 2. 3.
STEP 5 B C (H6) (H6) B C 1. 2. 8 Slide the inner hang rod (B) into the outer hang rod (C) ensuring the bottom holes are on the outer edges. Inset assembled hang rod (A & B) onto the hang rod brackets (H6) and lock into position.