Instruction Manual

LAC Series Oven Owner’s Manual MAINTENANCE
Version 1 35
Copyright © 2012 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
6.6.2. Replace
Heater Unit
Tools needed: 3/8" wrench, T20
Torx bit driver
1. Remove the floor plate.
a. Remove the
screws from the
floor plate
(Figure 10).
b. Lift the floor plate out of the oven to
expose heater panel/inlet cone (Figure
11).
2. Remove side walls by removing the screws on the front
edge of each panel (Figure 12).
3. Disconnect the heater leads from heater element with
wrench.

Before disconnecting leads, carefully
diagram (or note) which wires connect to
which terminals.
Figure 10. Remove Screws to Remove Floor Plate.
Figure 11. Heater Panel and Inlet Cone.
Figure 12. Remove Screws to
Remove Side Panels.