Instruction Manual

LAC Series Oven Owner’s Manual MAINTENANCE
Version 1 37
Copyright © 2012 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
17. Install the fan motor.
a. Insert shaft seal onto shaft.
b. Insert the shaft into shaft collar.
c. Fasten motor to plug assembly with the four screws.
18. Install fan wheel onto motor shaft.
19. Replace and fasten the fan inlet cover.
20. Adjust the fan wheel for 3/16 inch clearance between the wheel and the inlet ring and
tighten the set screws on the fan wheel. Check that the set screws hit the flats machined
into the motor shaft.
21. Replace and fasten heater.
22. Replace fan and heater plug assembly in oven body.
23. Replace left side wall.
24. Replace and fasten floor plate.
25. Replace fresh air damper arm assembly.
26. Replace fresh air damper handle.
27. Connect heater leads to circuit board.
28. Connect motor wire harness and fasten motor and heater ground wires to ground stud.
29. Connect thermocouple wires to control.
30. Replace control panel in oven body.