Manual

31
Operating Procedure
Starting the Oven
1. Turn the yellow/red DISCONNECT SWITCH to ON.
2. Press the POWER switch to ON.
• The DOOR RELEASE pushbutton will illuminate. This means the door
can be opened. NOTE that during the process cycle the DOOR
RELEASE pushbutton will not be lit; this means that the door may not be
opened.
• (optional beacon light-equipped units) The amber (center) beacon light will
illuminate, indicating that the oven is ready to receive work to be
processed.
3. To open the oven door, press the DOOR RELEASE pushbutton and at the same
time, press on the door. The oven door will unlatch and open.
4. The heater is wired in series with the door switch. The door must be completely
closed and locked to activate the heater.
Sequence of Operation (with Optional Beacon Light)
This section describes operation of the oven with the optional beacon light feature.
1. After the system is powered up (see above procedure), the Protocol Plus
controller is initialized.
2. At this point the oven is idle, empty, door closed, and waiting for the next lot to be
processed. The Protocol Plus is not running a profile. The amber beacon light is
on steady for steps 2 through 5, until profile is started.
3. Open the oven door.
4. Place the product on the shelf in the oven. Close the oven door.
5. Run the desired profile from the Protocol Plus controller.