Manual
63
Enable Page (Defaults on Page 72)
The Enable Page controls access to the other Setup Pages. The setpoint minimum and
maximum values, and the security passwords are also set on the Enable Page.
To access the Enable Page, enter the Setup Mode using a level 2 access code (see
description earlier in this manual). Press the Page key until Enable is displayed. Press
the Menu key. Each parameter can be changed by pressing the Menu key until the
desired parameter is displayed, and then pressing the keys to change the value.
NOTE: Changing the enable to “yes” for each page will allow access to the page in
Level 1 security.
Menu Item Display Description Range
Profiles Enable Profile
1-8
Controls access to Program Page
Yes or No
Autostart Enable Auto
Start
Controls access to AutoStart
Page
Yes or No
PID Enable PID Controls access to PID Page Yes or No
Control Enable Control Controls access to Control Page Yes or No
Communication
Enable
Communication
Controls access to
Communication Page
Yes or No
Real Time
Clock
Enable Clock Controls access to Real Time
Clock Page
Yes or No
Relay outputs Enable Relay
1-4
Controls access to Relay Page Yes or No
Test Enable Test Controls access to Test Page Yes or No
Zone
Calibration
Enable Zone
Cal
Controls access to Zone
Calibration Page
Yes or No
Sensor
Calibration
Enable Sensor
Cal
Controls access to Sensor
Calibration Page
Yes or No
Setpoint lower
limit
Enable
SPLowerLim
Sets minimum setpoint allowed -73°C to 760°C (-100°F to
1400°F)
Setpoint upper
limit
Enable
SPUpperLim
Sets maximum setpoint allowed -73°C to 760°C (-100°F to
1400°F)
High limit
overhead
Enable
HiLimOH
Sets maximum high limit setpoint
allowed*
3 to 11°C (5 to 20°F)*
Password level
1
Enable
Password 1
Sets password for access level 1 0 to 1000
Password level
2
Enable
Password 2
Sets password for access level 2 0 to 1000
Setpoint
Change
Enable
SPChange
Set to DISABLE to lock out
setpoint and high limit setpoint
changes in Manual and Timer
Modes
Yes or No
Analog Output
Type
Enable Analog
Type
Sets Analog Output type Ctrl or Proc
* Maximum high limit setpoint = SPUpperLim + HiLimOH