QT605 THIN LINE IN-CEILING QUICK MOUNT 2-WAY SPEAKER Installation & Operation Manual
Introduction Congratulations on your purchase of an Destination Audio QT605 thin line inceiling 2-way speaker! Your speaker is the result of many years of research and development dedicated to producing high quality products for home audio and audio/video systems. This manual contains features, setup recommendations and specifications for the Destination Audio QT605 thin line in-ceiling 2-way speaker.
Features The QT605 is the budget-minded answer for both residential and commercial in-ceiling speaker applications. The QT605 employs a 6½-inch polygraphite woofer cone and a 1-inch swivel fabric dome tweeter for great sound on a budget. The QT605 speaker is manufactured with high quality components and engineered to accurately reproduce music. Mounting flush to a wall or ceiling, architectural speakers are ideal for many applications where traditional speakers may be impractical or impossible.
Speaker Placement With nearly endless placement options, careful consideration for placement of the QT605 in-ceiling speaker needs to be considered, as installation requires cutting a hole in your wall or ceiling! When using the QT605 in home theater applications follow the guidelines illustrated below. Swivel Tweeter Placement The QT605 has a swivel tweeter allowing sound to be directed toward or away from the listening area depending on the application.
Installation CAUTION: Be certain there are no electrical wires, water pipes, heating ducts or any other obstructions in the planned area of installation before starting to drill or cut into the ceiling or wall. If there is an electrical outlet nearby, turn off the circuit breaker to avoid possible injury. 1. These speakers are designed to be mounted between the framing members. Use a stud finder to locate the positions of joists and rafters.
Installation (continued) 8. Using the supplied grille adhesive, apply an ample amount of adhesive around the grille. Gently push the grille onto the speaker securing the grille to the speaker. 9. To remove the speaker, insert the L-shaped tool’s hex-end into the tab hole to engage cam mechanism, turn counterclockwise until cam locks in open position. Repeat for remaining cams then remove speaker.
Specifications Model: QT605 Series: Builders Thin Line Quick Mount System Type: In-ceiling 2-way Speaker Frequency Response: 56Hz-20kHz ±3dB Sensitivity: 88dB (2.83V/1 meter) Recommended Power: 2-60 Watts Woofer(s): (1) 6½” (165mm) Polypropylene Cone Tweeter(s): (1) 1” (25mm) Swivel Fabric Dome Crossover Frequencies: 3,000 Hz Crossover Slope: 12dB/Octave Impedance: 8 Ohm Cabinet/Color: White Frame (paintable) Grille: White Powder Coated Steel (paintable) Cutout Dimensions: 8.
Troubleshooting Situation No sound from speakers. No sound from one speaker. Probable Cause Speaker wire not connected. Solution Make sure wire is properly connected at both the speaker and the amplifier observing proper polarity. Speaker selector on amplifier is not on. Activate proper speaker selector on amplifier. Balance control on receiver or Place balance control in preamp is not centered. the center. Speaker wire not completely connected. Very little bass and/or imaging.
This page was left blank intentionally 8
382 Marshall Way, Layton, Utah • USA • 84041 Phone: (801) 660-2400 • Fax: (801) 543-3300 www.destinationaudio.com It is Destination Audio policy to continuously incorporate improvements into our products; all specifications are subject to change without notice. Copyright © 2010 Destination Audio. All Rights Reserved.
