Specifications

ACCESSORIES
Flame K.3 Accessories 52-1002-5 9/01/2008
Laser Aimer, Laser Holder, W6300 Detector Inspector
Laser Aimer/Cone of Vision Tester is for use with the Q1201A and Q1201C Laser Holder in
sighting and testing the area of flame detection coverage. Battery-powered laser projects a red
beam of light and has a rotary switch for turning the device on and off. When used with its holder,
the laser beam identifies the center and edges of the detector's COV. Includes battery.
Q1201A Laser Holder (Manual: 95-8404) is for use with the Laser Aimer for sighting and testing
area of flame detection coverage. Easily attaches to the front of Det-Tronics' older model UV,
single frequency IR and UV/IR detectors for use during system startup, checkout, and re-
alignments. Designed to hold the Laser Aimer (which projects a red beam of laser light) to show
exact location of the center of the detector's COV. Two additional holding positions are available
for locating the outside edges of the COV at either 40 degrees off center (80 degrees total COV)
or at 45 degrees off center (90 degrees total COV). While laser is being used to locate edges of
the COV it can be rotated 360 degrees to identify the entire area of flame detection coverage.
Q1201C Laser Holder is for use with X3301, X3302, X2200, X5200, X9800 and X3300 flame
detectors. Easily attaches to the front of Det-Tronics' X-Series flame detectors for use during
system startup, checkout, and re-alignments. Designed to hold the Laser Aimer (which projects a
red beam of laser light) to show exact location of the center of the detector's COV. Two additional
holding positions are available for locating the outside edges of the COV at either 30 degrees off
center (75 degrees total COV) or at 45 degrees off center (90 degrees total COV). While laser is
being used to locate edges of the COV it can be rotated 360 degrees to identify the entire area of
flame detection coverage.
W6300A Detector Inspector (Manual: 95-8503) for use with U7602E, U7698E and U7652B
flame detectors with time, date, fire, and fault stamping feature. Software included.
W6300B Inspector Connector with Inspector Monitor Software for use with X3301, X3302,
X5200, X9800 and X2200 flame detectors. Allows for validation of configuration and uploading of
important detector status data such as power-up/down, faults and alarms
to a personal computer (PC) where it can be displayed, saved and/or printed.