Manualshelf

Instructions / Assembly

ManualsBrandsDetail K2 ManualsAutomotive1639 lbs. Payload Capacity 4.5 ft. x 7.5 ft. Galvanized Steel Utility Trailer with Bed Tilt and Collapsing Ends
12345678910
v.171214 En.a7
ENGLISH
STEP 6
Pre-Wiring
The wire harness are pre-assembled under the frame. The pre-assembled wiring
harness is pre-mounted on the trailer and must be connected to the harness that goes
to the front of the trailer tongue.
NOTE: Make sure all connections are accessible for light mounting when
trailer is fl ipped over.
Mount the light assemblies onto the side of the rear portion of the frame using the M6
square neck bolts, M6 washers and M6 nylock nuts. Plug the light connector into the
wire harness. Mount the side marker onto the side of the front portion of the frame
using the self-tapping screws. Plug the light connector into the wire harness.