Use and Care Manual

channel you must ensure that it is mounted on a flat surface so that the three

major sections (motor, drum and gear housing) are properly aligned. Proper

alignment of the winch will allow even distribution of the full rated load.

2. Start by connecting the roller fairlead (Part# X950700) to the mounting channel

using 2 each of the cap screw M10 X 35 (Part# X950002), flat washer (Part#

X950004), lock washer (Part# X950003) and securing with locknut M10 (Part#

X950024) (Make sure the screw is placed through the mounting channel and

roller fairlead from inside the channel. This will allow enough clearance for the

winch to be placed in the channel without obstruction.)

3. Assemble the winch to the mounting channel by first pulling and releasing the

clutch knob to “CLUTCH OUT” position. Pull out a few inches of cable from the

drum and feed the wire loop through the opening in the front of the mounting

channel and roller fairlead.

4. Connect the battery and motor leads as the drawing above. Keep in mind that

every type of winch is different each other.

5. Connect the winch motor leads as detailed below:

CAUTION – Batteries contain gases which are flammable and explosive.

Wear eye protection during installation and remove all jewelry. Do not lean over

battery while making connections.