User Manual

RD-8X-N4X Operators Manual
3 ** 16 2 3
4 ** 16 3 4
5 ** 16 4 5
6 ** 16 5 6
7 ** 16 6 7
8 ** 16 7 8
9 ** 16 8 9
10 ** 16 9 10
11 ** 16 10 11
12 ** 16 11 12
13 ** 16 12 13
14 ** 16 13 14
15 ** 16 14 15
16 ** 16 15 16
**- Represent the modbus address of the remote device. The slave ID for each channel enabled on the RD-
8X must match the modbus address of the remote device. Failure to assign the proper slave ID will result
in a “COMM ERROR” for the corresponding channel.
NOTE: The number of activated channels can be less than (but not greater than) the controller’s
maximum input capacity. The maximum input capacity is 16 channels.
4.3.2 Model RD-8X to Model 10X / 12X
Table 2
RD-8X: Setup Channel Data Model 10X / 12 X
Channel Slave ID Register to Read Reading Register Channel
* ** 6 1 1
* - Represents RD-8X channel the remote device will be assigned to.
** - Represents the modbus address of the remote device. The slave ID for each channel enabled on the
RD-8X must match the modbus address of the remote device. Failure to assign the proper slave ID will
result in a “COMM ERROR” for the corresponding channel.
NOTE: The number of activated channels can be less than (but not greater than) the controller’s
maximum input capacity. The maximum input capacity is 16 channels.
4.3.3 Model RD-8X to Model 140
Table 3
RD-8X: Setup Channel Data
Model 140
Channel Slave ID Register to Read Reading Register Channel
* ** 7 0 ***
* - Represents RD-8X channel the remote device will be assigned to.
Model RD-8X-N4X Operator Manual Rev. 1.0 Page 8 of 14