Operating instructions

DIGITAL HEIGHT ROD INSTRUCTIONS

Digital Height Rod Installation

Before starting installation, please unpack carefully and remove all plastic wrappings, foam

fillers and cardboard material. You should have the following components:

(1) Detecto Digital Height Rod (DHR)

(2) Mounting Brackets

(1) Hardware Pack, containing:

(8) M4x0.7x4 Pan Head Machine Screws (bracket to height rod)

(4) #10x1/2” Hex Head Sheet Metal Screws (bracket to column)

1. Align a mounting bracket with the holes in the height rod (near the headpiece) and install

four (4) M4x0.7x4 Pan Head Machine screws to secure the bracket to the height rod.

2. Next, align the other mounting bracket with the lower holes in the height rod and install four

(4) M4x0.7x4 Pan Head Machine screws to secure the bracket to the height rod.

3. Align the mounting bracket (near the headpiece) with the holes in the back of the column

close to the display and install two (2) #10x1/2” Hex Head Sheet Metal screws to secure

the bracket to the column.

4. Align the holes in the other bracket with the lower holes in the column and install two (2)

#10x1/2” Hex Head Sheet Metal screws to secure the bracket to the column.

5. Connect the cable from the DHR to the port on the rear of the 758C indicator that is labeled

height rod. Refer to the 758C Owner’s Manual, 8555-M210-O1 for additional information.

0033-M114-O1 Rev F x Model 6437 Series