Operating instructions

DIGITAL HEIGHT ROD INSTRUCTIONS, CONT.
Measuring Patient’s Height
IMPORTANT! Before performing the operations on this page, the digital height
rod must
be in its “starting position” (inner sliding tube must be down
completely inside outer stationary tube and headpiece folded flat against
stationary tube) prior to turning on the indicator. Otherwise, the error message
999
.
9
will be displayed.
1. Make sure height rod is in starting position.
2. Press ON/OFF key to turn indicator on.
3. Press ZERO key to zero weight display. ZERO, GROSS and lb, oz, kg or ST
annunciator will turn on to show scale is ready for use. Note that height reading will
show
3-&3
FT-INCHES or
110
.
0
cm (depending on
Unit=
setting in Setup
¾
).
4. Patient may now step onto scale platform.
5. Grasp height rod at hinge pin and raise it well above patient’s
head and then lift headpiece to horizontal position. Carefully
lower height rod until headpiece rests on top of patient’s head.
NOTE: If the patient is under 3 ft, 7.3 in (110 cm) or over 6 ft,
7.1 in (201 cm) return the digital height rod to the “starting
position” and manually
¾
enter the patient’s height.
6. BMI will automatically be displayed with height.
7. Read weight, height and BMI displays.
8. While holding headpiece horizontal, raise height rod well
above patient’s head.
Grasp at Hinge Pin
9. Patient may now step off scale platform.
10. Return height rod to starting position.
11. BMI display will clear when weight returns to zero.
¾
Refer to the 758C Owner’s Manual, 8555-M210-O1 for additional information.
OPTIONAL WHEELS INSTALLATION
How to Setup the Scale with Roller Wheels.
1. Remove the two lower screws in the back
of the column.
Screws and
wheel bracket
2. Place the wheel bracket against the back of
the column and align the holes in the
bracket with the holes in the column.
3. Install the two screws removed in step 1,
securing the wheel bracket to the column.
0033-M114-O1 Rev F x Model 6437 Series
11