Product Manual

1930-M458-O1 Rev-G y Bariatric Waist-High 685X Series 10

DIGITAL HEIGHT ROD INSTRUCTIONS

Digital Height Rod Installation

Before starting the installation, please unpack carefully and remove all plastic wrappings, foam

fillers, and cardboard material. You should have the following components:

Item Qty Description

1 1 Detecto Digital Height Rod (DHR)

2 4 #10 x 1/2” Hex Head Sheet Metal Screws (brackets to column)

3 2 Mounting Brackets

4 8 (2) M4 x 0.7 x 5 Phillips Drive Pan Head Machine Screws (height rod to brackets)

5 3 Cable Clip

1. Align a mounting bracket with the holes in the height rod (near the headpiece) and install

four M4 x 0.7 x 4 Pan Head Machine screws to secure the bracket to the height rod.

2. Next, align the other mounting bracket with the lower holes in the height rod and install four

M4 x 0.7 x 4 Pan Head Machine screws to secure the bracket to the height rod.

3. Align the mounting bracket (near the headpiece) with the holes in the back of the column

close to the display and install two #10 x 1/2” Hex Head Sheet Metal screws to secure the

bracket to the column.

4. Align the holes in the other bracket with the lower holes in the column and install two

#10 x 1/2” Hex Head Sheet Metal screws to secure the bracket to the column.

5. Connect the cable from the DHR to the port on the rear of the indicator that is labeled

Height Rod, routing the cable as shown in Detail B.

For additional information, refer to the MedVue MV1 Owner’s Manual (8555-M512-O1) for

the 6854DHR or 6857DHR, and the MedVue MV2 Owner’s Manual (8555-0530-0M) for the

6854KGEUDHR or 6857KGEUDHR

See Detail

Column

Detail A

See Detail B

Detail B