Product Manual

0065-0647-0M Rev A  7550 FOLD-UP STATIONARY SCALE

Step 5 – Install the Weight Indicator

1. Remove the weight indicator from its box and unpack it. Obtain and install

six “C”

batteries in the indicator.

2. Assemble the indicator swivel ball socket mount and then place it over the bolt and

washer on the top right of the scale frame.

3. To install the indicator, slightly loosen the adjustment knob to allow the two parts of the

socket to open enough to insert the rubber ball and place the rubber ball on the back of the

indicator into the swivel ball socket mount. Tighten the adjustment knob slightly to secure

the indicator for the next step.

4. Turn the indicator around (display away from you). Locate the 9-pin load cell connector on

the back panel of the indicator. Align the long edge of the load cell cable connector with

the long edge of the indicator connector. Place the load cell cable connector on the

indicator connector and secure using the load cell cable retaining screws.

5. Adjust the indicator to the desired viewing angle and direction and then tighten the

adjustment knob.

NOTE: For more detailed information on installing the batteries, connecting the load

cell cable and mounting the weight indicator on the scale, refer to the MedVue Model

MV1 Medical Weight Analyzer Owner’s Manual, 8555-M512-O1.

Adjustment

Knob

Swivel Ball

Socket

Mounting Bolt

and Washer