Instruction manual

OPERATION

Weighing

1. Make sure that nothing is on the scale platform.

2. Press and hold the Time/Weight key for 3 seconds to change to the Weighing mode.

3. First “---“ will appear on the display, followed by “0.00kg” if the weighing unit switch is

set to kg, or “0.0 lb.oz” if it is set to the lb.oz position.

4. Place the baby on the tray.

5. The display will show the baby’s weight.

6. Note that if there is no change in weight for 2 minutes, the scale will return to the Clock

mode. Otherwise, press and hold the Time/Weight key for 3 seconds to go back to the

Clock mode.

 DO NOT LEAVE BABY UNATTENDED ON BABY TRAY.

 FAILURE TO MAINTAIN CONTINUAL CONTROL OF BABY BEING

WEIGHED CAN RESULT IN SERIOUS INJURY SHOULD BABY FALL

FROM SCALE.

Hold Weight Display

1. When the baby’s weight is displayed, press the Hold / Release key once to hold the

weight on the display.

2. After recording the displayed weight, press the Hold / Release key once to release the

weight display and return to weighing mode.

Tare Function

1. When the TARE key is pressed “t” and then “0.00kg” (or “0.0 lb.oz”) will appear on the

display.

2. When the infant is removed from the scale after being weighed in the Tare mode, the

display will show a negative weight value.

Memory, Recall and Difference Function

1. Press the Memory key. The current weight on the platform and time and date will be

saved in memory.

2. Press the Recall key while the scale is in the Weighing or Clock mode. This will cause

the previously saved weight (and time and date) to be shown on the display along with

the  symbol. The recalled weight will be displayed for about 4 seconds and then the

date and time when the weight was saved will appear.

3. Note that the saved weight will be retained until a new value is saved.

4. Press the Difference key to show the difference between the current and saved weight

along with the  symbols. Thereafter the date and time of the last saved weight will

be displayed. If the current weight is higher than the saved weight, the difference will be

shown as a positive value. If the current weight is lower than the saved weight, a

negative value will be shown.

5. The Difference key will only operate when the scale is in the Weighing mode.

8535-M215-O1 Rev C  8440 Operation