Product Manual

0065-0834-0M Rev C • 8500/8550 Service Manual
14
PARTS IDENTIFICATION, CONT.
8550 Final Assembly – 0065-0812-0A
ITEM
QTY
PART NUMBER
DESCRIPTION
31 1 6680-1043 GROMMET 1/4 ID X 5/8 OD FOR 1/8 TK PNL
32
1
391rv204
1/4-20 ELASTIC STOP
33 1 6680-0250 SPACER .26 ID X .5 OD
34 1
6024-1066 WASHER FLAT 1/4 X 1
35 1 593GR986 SERIAL TAG ASSY
36
1
5930-B104-08
LABEL: DETECTO LOGO W/WEB SITE (3" x 10")
37 1 0065-B403-0A CABLE, INDICATOR
38 1
0065-0826-08 8500/8550 WEIGHBRIDGE SKID MAT
39
2
0065-0828-08
8500/8550 RAMP SKID MAT
40 1
0065-B392-08 SAFETY PIN WARNING LABEL
NOTES:
1. Wire indicator and load cell cables as shown in schematic. Check to make sure that none
of the indicator cables, or load cell cable wires are crossed, or touching where they connect
to the trim board to avoid a short circuit. Route cables through available holes.
2. Ensure correct wiring occurs before addition of cover plate.
3. Calibrate and set up indicator per Test Procedure section.
4. Prepare surface per APPLICATION OF ADHESIVE/ADHESIVE BACKED ITEMS section
before applying item 35, 36, and 40.
5. Remove ramps and package separately for shipping.
6. Center label as closely as possible and offset from edge of deck using given dimensions.
7. Ensure Loctite packet (6560-1046), screws qty. 4 (6021-1812), and hex key
(M220-0080-00) are added to package before shipping.
8. Cutout items 21 and 22 per dimensions of weighbridge and ramps.