Product Manual

CONFIGURATION, Cont.

GRAVITY COMPENSATION

1. With the display showing

Oaf

, press the press UNIT key 4 times. The display will

change to show

GRAU

2. Press the HOLD key.

To Enable the Gravity Compensation mode, press the UNIT key. The display will

change to

To Disable the Gravity Compensation mode, press the UNIT key The display will

change to

OFF

3. Press the HOLD key again. The display will change to show

GrAu

4. Press the UNIT key. The display will change to show

End

5. Press the HOLD key to save the settings and reset the scale.

6. Setup is complete.

GRAVITY COMPENSATION

The Gravity Compensation for your scale has been pre-configured at the factory and should

not require changing in most locations. In the event that the factory settings do not meet the

requirements of your location, contact the factory for the value for your location.

With

GrAu

enable from the function setting of the Configuration mode, the scale will use

the factory set value of 9.796 for the Gravity Compensation.

If the

GrAu

is disabled, the scale will use the value obtained from the factory and

entered by the operator for the Gravity Compensation.

TO CHANGE THE GRAVITY COMPENSATION VALUE:

1. Press the ON/OFF key to turn on the scale.

2. Press and hold the UNIT key 3 seconds to enter Gravity Compensation mode, the

display will show 9.796 (or the current value).

3. Enter the desired gravity value (press the UNIT key to choose number from 0~9, and

press HOLD key to move to right digit.

4. Press TARE key (to confirm the entered gravity) and return the scale to the normal

operating mode.