Product Manual

1961-M008-O1 VET-50
Page 2
UNPACKING INSTRUCTIONS
The VET-50 is shipped in two (2) cartons. One carton will contain the weight indicator and the
other carton will house the scale base (with 8 ft. coiled cable), the Stainless Steel deck, the
rubber mat, and the Desk stand/Wall mount bracket for the indicator.
Before starting to assemble, please unpack carefully and remove all wrappings and fillers.
Inspect the unit for any signs of damage due to shipping, such as exterior dents and scratches.
It is the responsibility of the Purchaser to file all claims for any damages or loss in transit
incurred. Retain packing and shipping carton for return of scale if necessary.
INSTALLATION
Installing the Deck
To install the Stainless Steel deck on the scale,
place the scale base in front of you on a desk or
table with the slotted end to your right. Tilt the deck
to a 45° angle and slide the deck over the base
aligning the pin on the bottom of the deck with the
slot in the scale base. Lower the left side of the
deck onto the base aligning the pin with the hole in
the scale base. Refer to Figure No. 1.
Interconnections
Both the VET-50 scale base and power connections
to the weight indicator are made at the bottom rear
panel of the indicator. Refer to Figure No. 2 for the
rear panel layout.
Scale Base Connection
The scale base connection to the weight indicator is made via an 8 ft. coiled cable with a
modular type connector on one end and a 9-pin "D" type connector on the other. The modular
connector of the coiled cable should be inserted into the mating connector socket on the scale
base until it locks into place. The 9-pin connector plugs into a 9-pin "D" type jack located on
the bottom rear panel of the indicator and is secured by two (2) screws.
Power
Su
pp
l
y
Scale
Base
Cable
Figure No. 2
Figure No. 1
Battery
Cover