Product Manual

11
Interval (ms)
Set the “Interval” for on-demand requests in milliseconds. 300 milliseconds is approximately
three times a second.
Start Chrs
Set the character that is the last character sent from the indicator for a weight record. For SMA
format this is a carriage return, represented as %0D.
End Chrs
Set the character that is the first character sent from the indicator for a weight record. For SMA
format this is a line-feed, represented as %0A.
Min Len
Set the minimum length for a weight record.
Max Len
Set the maximum length for a weight record.
Wt Start Pos
Set the position in the record where the weight value starts.
Wt End Pos
Set the position in the record where the weight value ends.
DP Offset
Check “DP Offset” if the status positions are one character further to the right when the weight
value contains a decimal point.
Status (OV, BZ, MO, CZ)
Click the appropriate tab to set the status position and character for each condition over capacity,
below zero, motion, and center of zero.
Units (TN, LB, KG, MT, TON)
Click the appropriate tab to set the units position and character for each unit, short tons, pounds,
kilograms, metric tons, or long tons.
Mode (G, T, N)
Click the appropriate tab to set the mode position and character for each mode, gross, tare, or net.
Indicator Command Codes (ZERO, UNITS, GROSS, TARE, NET, OP1, …)
Click the appropriate tab to set the codes for each indicator command such as “Zero” and
“Units”.
Print Capture