Product Manual

29
Win-DDE is written in Microsoft Visual C++ using the Microsoft Foundation Classes.
Win-DDE is a multi-threaded Win32 application providing high-performance.
Win-DDE uses Winsock 1.1 or 2.0 for TCP/IP communications.
Predefined Device Profile Information
205CAP – Permits print capture of gross, tare, and net weight.
205 Setup –
1. Press “*”. The display will show “Funct=”. Press “REVIEW”.
2. The display will show “PUO=” Press “ENTER”. The display will show “no”. Press
“ENTER.”
3. The display will show “SLEEP=”. Press “ENTER”. The display will show the sleep
value. Press “ENTER”.
4. The display will show “A off=”. Press “ENTER”. The display will show the auto-off
setting. Press “ENTER”.
5. The display will show “CLTar=” Press “ENTER”. The display will show the clear-tare
setting. Press “ENTER”.
6. The display will show “Sio?” Press “ENTER”. The display will show “no”. Press the “*”
key to change the display to “YES”. Press “ENTER”.
7. The display will show “bAUd=” Press “ENTER”. The display will show the current
baud rate setting. For the default 9600 baud press the “*” key until the display shows
“96”. Press “ENTER”.
8. The display will show “PrtY=” Press “ENTER”. The display will show the current parity
setting. For the default no paraity press the “*” key until the display shows “0”. Press
“ENTER”.
9. The display will show “BitS=” Press “ENTER”. The display will show the current data
bits setting. For the default eight data bits press the “*” key until the display shows “8”.
Press “ENTER”.
10. The display will show “StoP=” Press “ENTER”. The display will show the current
stop bits setting. For the default one stop bit press the “*” key until the display shows
“1”. Press “ENTER”.
11. The display will show “Cont1=” Press “ENTER”. The display will show the current
setting for continuous data for serial port one. For printer capture the indicator must not
be continuous. Press the “*” key until the display shows “no”. Press “ENTER”.
12. The display will show “Cont2=” Press “ENTER”. The display will show the current
setting for continuous data for serial port one. For printer capture the indicator must not
be continuous. Press the “*” key until the display shows “no”. Press “ENTER”.
13. The display will show “Print?”. Press “ENTER”. The display will show “no”. Press
the “*” key to change the display to “YES”. Press “ENTER”.
14. The display will show “Port=”. Press “ENTER”. The display will show the serial port
selected for printer output. Press the “*” key to set this to the correct port to be
connected to the computer. If only one serial port is wired from the 205 indicator this
would usually be “1”. Press “ENTER”.