Owner manual

MARK HOLES
trim side only, 4 places
Drill 1/2" diameter holes thru
NOTES:
1. Mortise lock NOT supplied with TRIM device.
2. For a retrofit application, remove lock and device before installing new trim.
3. LHR installation shown (Reverse all steps for RHR).
Install TRIM device
#1/4 lock washer
Install backplate with
(4) "A" screws
A
#1/4-20 x 1"
Machine Screw
Turn handle and plate
180°. Replace plate
and tighten Allen screw
(Place trim on a clean surface with this view facing up)
TRIM INSTALLATION COMPLETE
1. Continue installation using device instructions (p/n:101349).
2. For modular cable devices, see electrical instructions
for cable routing.
#1/4 lock washer
Lock washer
Mark centerline for trim 40" above finished floor
Mark trim
holes
Mark trim
holes
Switching Handing from
RHR to LHR
Pull back blocking plate
Caution:
Do not lose the brass
shear pin located
inside assembly.
Use 1/8" Allen Wrench
to remove screw
LHR Trim Side
Lock
Centerline
TRIM side: Use plastic template to mark and drill TRIM holes
1
STEP 1: PREP DOOR
02 LEVER TRIM
INSTALLATION INSTRUCTIONS
2
STEP 2: INSTALL TRIM DEVICE