User guide

ManualsBrandsDetex ManualsSafety14DV Trim

Detex Corporation, 302 Detex Drive, New Braunfels, Texas 78130-3045 (830)629-2900 /1-800-729-3839 /FAX(830)620-6711

E-Mail: detex@detex.com Internet: www.detex.com

INSTALLATION INSTRUCTIONS FOR ADVANTEX TRIM

OUTSIDE LEVER TRIM 08/09/14

(08 Trim - includes 08D, 08DT, 08DU)

(09 Trim - includes 09D, 09DT, 09DU)

(14 Trim - includes 14D, 14DT, 14DU)

101295 September 14, 2009

TOOLS AND SUPPLIES

Safety Glasses

(Always put on safety glasses prior to beginning installation of unit)

Pencil

1/8” Hex Wrench

Center Punch

Hammer

Drill Motor

Drill Bits & Taps

Screw Driver (Flat Head & Phillips Drive)

Tape Measure

DETEX INS-101295 Page 1

Summary of content (5 pages)

PAGE 1
® 101295 September 14, 2009 Detex Corporation, 302 Detex Drive, New Braunfels, Texas 78130-3045 (830)629-2900 /1-800-729-3839 /FAX(830)620-6711 E-Mail: detex@detex.com Internet: www.detex.
PAGE 2
PREPARING THE TRIM 1. The lever trim is handed. Refer to “CHANGE LEVER HANDING” on pages 4 and 5 if needed. INSTALLING THE MORTISE CYLINDER -08 and 09 FUNCTIONS ONLY - Instruction 2 and 3: 2. A short cylinder collar is supplied for mortise cylinders 1” to 1-1/8” long. For cylinders greater than 1-1/8”, order tall cylinder collar part #100752-X. 3. Insert the mortise cylinder (not included). (See Fig. T8). Fasten the cylinder with the large hex nut.
PAGE 3
Fig. T9 11. Drill holes “a” according to the chart (Fig. T9). ASSEMBLING THE OUTSIDE TRIM AND BACKPLATE 12. Align the hex stand-offs and trim assembly through the drilled holes (Fig. T10). Fig. T10 13. Align the tail piece extension into the backplate’s trim cam on the inside face of the door. 14. Fasten the backplate to the inside face of the door with lockwashers and 1/4-20 machine screws provided with Exit Device Hardware Kit. Caution: The lever should easily operate the inside trim cam. 15.
PAGE 4
CHANGE LEVER HANDING (Refer to Fig. T11 on page 5) A. Remove tailpiece extension assembly screw. (Remove tailpiece extension assembly if necessary). B. Remove stop plate. C. Warning: Springs under pressure! Remove spring retaining plate. Carefully remove the springs. D. Switch lock spring to opposite side (for 09 Function only). E. Remove top gear. F. Loosen the clutch center screw approximately two (2) turns. Bend locking tab back to disengage with notch. G.
PAGE 5
RHR LHR LOCK SPRING (09 TRIM ONLY) LOCKING BAR SPRING RETAIN TOP GEAR TAILPIECE EXT. ASSEMBLY SCREW SPRINGS RACK CLUTCH GEAR LOCKING TAB STOP PLATE SEE STEP H View from back side (With Spring Retaining Plate Removed) Fig.