Owner manual

CHANGE LEVER HANDING
Locking Bar
p/n 101994
Tailpiece Assembly
screw
p/n PP-5367-108
Top Rack
p/n 100865
Lever
Bottom Rack
p/n 101457
Spring Retaining
Plate
p/n 100866
Springs
p/n 100877
& 101510
Hex Standoff
p/n 100777
RHR
LHR
Retaining Plate
Screws
p/n PP-5303-2
102995 Sheet 2 Side 2
Before removing Top and Bottom Racks, note tooth positions.
If excessive play exists on handle, confirm tooth alignment.
DO NOT
REMOVE SCREW
A. Remove tailpiece assembly screw. (remove assembly if necessary)
B. Remove hex standoff and two (2) screws holding spring retaining plate.
WARNING: Springs under pressure!
C. Remove Spring Retaining Plate.
D. (09 Function only) Move Lock Bar to opposite side.
E. Carefully remove springs and bottom rack.
F. Remove top rack.
G. Rotate lever to opposite side.
H. Engage bottom rack on the opposite side as s
hown.
I. Engage top rack on the opposite side as shown.
J. Install springs on bottom rack. WARNING: Springs under pressure!
K. Replace Spring Retaining Plate, hex standoff and screws.
L. Replace tailpiece assembly screw.
Handing Complete
Center screw
p/n 100822-1