Owner manual

Detex Corporation, 302 Detex Drive, New Braunfels, Texas 78130-3045
[phone] / 1-800-729-3839 / Fax [phone]
E-MAIL: [e-mail] INTERNET: www.detex.com
INSTRUCTIONS AND SPECIFICATIONS FOR DS-1581-LBM ELECTRIC STRIKE
104812 February 8, 2010
APPLICATION:
Remote central station notification
Local alarm monitoring
Triggering video surveillance and
recording systems
Active relay for trap door systems
For indoor applications ONLY.
INFRARED
SENSOR
SENSOR WIRE
COLOR CODE
POWER LEADS:
RELAY LEADS:
PREINSTALLATION CONSIDERATION:
LB SENSOR WIRE TERMINAL
COLOR CODING ASSIGNMENTS
TECHNICAL SPECIFICATIONS:
FEATURES:
RELAY
RELAY
WIRING SCHEMATICS FOR TYPICAL APPLICATIONS
•
•
•
•
•
Red - Positive
Black - Negative
Blue - Common
Yellow - Normally Open (NO)
White - Normally Closed (NC)
•
•
•
•
•
•
•
•
•
SHARP Infrared optical sensor
Normally Open and Normally Closed
contact terminals
Single pole, double throw, Form “C”
relay, rated at 1 Amp at 24 VAC or
24 VDC.
Sensor Power - 12 through 30 VDC (ONLY)
Non-Mechanical operation
Sensor is concealed within the unit
Sensor does not require any adjustment
Ignores ambient light, detecting radiant
Infrared reflections off the pullman latch
Increase life and decrease in maintenance
due to electronic versus mechanical
operation
®
When Mounting, the pullman latch must be positioned as close
as possible to the vertical center of the latch cavity. Having the latch on
center will ensure that the sensor will have enough surface to detect.
You can use the 1/8” spacer (included) to move the DS-1581-LBM close
to the panic bar.
QUIESCENT TRIGGER
VOLTAGE CURRENT DRAW CURRENT DRAW
12 VDC 13mA 23mA
24 VDC 20mA 35mA
30VDC 22MA 39mA
NOTE:
Please observe proper polarity for the LB sensor. The RED wire
terminal must be attached to the POSITIVE side and the BLACK wire
terminal must be attached to the NEGATIVE side.
RED +
BLACK -
BLUE COMMON (COM)
YELLOW - NORMALLY OPEN (NO)
WHITE - NORMALLY CLOSED (NC)
TO TRANSFORMER
12V THROUGH 30V DC
RELAY TERMINALS
TO USER DEVICE OR
SENSORS.
For an alarm system a
Buzzer or Bell can be
wired to the NO terminal
such that when the door
is open the Buzzer or Bell
will sound.
For a security system
setup one side of the
circuit can be connected
to the common and the
other side to the NC
terminal so that when the
door is open, the system
senses the relay switch
as open
COMMON
NO
NC
TRANSFORMER
POWER
BUZZER OR
BELL
COMMON
NO
NC
SECURITY SENSOR
1/8” Spacer
Questions? Contact Customer Serv i c e a t 1 - 8 0 0 - 7 2 9 - 3 8 3 9