User guide

DETEXI Basic Configuration 12 - 31
9 Connection settings can be changed. Click Save button to save changes.
9 The authorization will be required — credentials supplied by the NVR administrator
should be provided.
9 The NVR Domain Controller has the same graphical user interface named NVR
Control Center as the NVRs just with expanded functionality.
2. Reject Registration Request
1. In the Domain Controller NVR Control Center go to General — NVR Locations (Fig 5).
2. A NEW location appears in the Servers Locations list defining the NVR-requester settings —
3. Click Unregister button. Provide credentials. The NEW NVR location will be deleted from the Servers
Locations list.
9 The NVR becomes unregistered — proper messages appear on both sides.
Ports Required to Be Open
What ports are required to be open for the DETEXI NVR operation?
For the full DETEXI NVR functionality administrator should open the necessary ports. NVR by default uses
the following TCP ports —
20, 21, 23
2080
60000, 60001
65235
9 If PortMapper service is used, all TCP ports being used by the service, should be
open.
Unregister Child NVR
Registered NVR and the NVR Domain Controller will stay logically connected until a request to unregister is
received. Request to unregister child NVR to exclude it from the domain network can be initiated on the
NVR or on the NVR Domain Controller side.
1. Unregister on NVR
To unregister on the child NVR side (Fig 6):