User guide

DETEXI Basic Configuration 21 - 31
the NVR before the connection will be terminated. User may login again if desired. A value of 9999
designates no time limit.
7. Check Master User checkbox to give the user permission to terminate other user sessions from the
Client — Get Users.
8. Check Can Search Archive checkbox to give the user permission to view NVR archive.
9 Remember that User Cameras to Interact also must be setup.
2. Define User Cameras to Interact
To define the cameras user has access to —
1. With the user selected choose the camera from the Cameras List at the left and click ">" button to
add the camera permission to the user — the camera name appears in the selected cameras list at
the right (Fig 10).
2. Select the camera name in the selected cameras list at the right.
3. Check proper checkbox under the User Rights to pass the previously configured camera
authentication settings — Adm, Oper or User.
9 The User Rights chosen for the first camera configured will automatically be assigned to each
camera after that unless manually changed.
9 It is necessary to assign the level of authentication allowed from this user to the camera defined
in the NVR Control Center — Cameras — Security & Alarm.
9 In most cases, the camera has only one username and password, with administrative privileges.
9 Be sure that User Rights settings make sense considering the authentication settings in the
Security & Alarm.
4. Check Can PTZ checkbox below the selected cameras list to give the user PTZ permission on
the selected camera.
9 PTZ permission is defined on a per-camera basis, and is enabled by default if the camera
has PTZ capabilities when assigned to the user.
5. Repeat steps 1-4 to add more camera permissions.
6. Click Save button below the Users List to save user settings.
3. Synchronize NVR Location
When you are ready for your changes to take effect, you should synchronize the services running on the
NVR holding the updated users list with the current configuration.
9 If updates were made to the Domain Controller Users list click Synchronize button in the top right
corner to activate the new configurations.
9 If a child NVR individual Users list was updated — synchronize the NVR from the Domain Controller
NVR Control Center — General — NVR Locations.