User guide

DETEXI Basic Configuration 23 - 31
y Setup camera recording instructions including alarms and motion detection
y Configure camera Inputs/Outputs etc.
For the detailed instructions, refer to the DETEXI NVR — Managing Cameras manual.
9 This Location means the NVR Domain Controller.
9 The NVR Domain Controller has the same graphical user interface named NVR
Control Center as the NVRs just with expanded functionality.
9
2. Synchronize Updates
When you are ready for your changes to take effect:
1. Synchronize the services running on the NVR Domain Controller with the current configuration by
clicking Synchronize button in the top right corner of the Domain Controller NVR Control Center.
2. Synchronize the services running on the child NVR holding the updated cameras with the current
configuration in the Domain Controller NVR Control Center — General — NVR Locations.
Event Management (Tasks)
The DETEXI NVR can be configured to respond to events all the time or at certain set times. The system
response configuration is based on the NVR Task Execution Engine. When the event is triggered, some
of the common responses can be configured. The NVR Domain Controller allows users to administer and
control all tasks configured in the domain from a single interface.
9 The NVR Domain Controller and every child NVR in the domain have their peculiar tasks applicable
to them.
1. Update Tasks
In the Domain Controller NVR Control Center — Tasks select a location from the Servers Locations list
(Fig 12). Then you can add new or view/update the selected NVR task —
y Define a new task
y Add/update action/notification to the task
y Create composite task
y View task usage info
y Configure task triggers etc.
For the detailed instructions, refer to the DETEXI NVR — Event Management manual.