User guide

DETEXI Basic Configuration 26 - 31
Setup Child NVR Check Alive Procedure
Although every NVR in the NVR Domain Controller configuration should have its own reliability settings
there is a new intercommunication layer between the NVR Domain Controller and a child NVR, which could
also fail and therefore the system administrator must be able to check its status.
To be aware weather all child NVRs are alive and properly respond to the NVR Domain Controller you
should launch Check Alive procedure to setup Task when NVR does not respond for each child NVR in
the NVR domain (Fig 14).
1. In the Domain Controller NVR Control Center go to the General — NVR Locations.
2. Select a child NVR from the Servers Locations list.
3. Switch to the Monitoring tab and check Check Alive check box.
4. Input your setting to define an Interval for monitoring (sec), number of Attempts and interval
between them.
5. Select an appropriate predefined task from the Task when NVR does not respond list.
Fig 14. Domain Controller NVR Control Center — General — NVR Locations
(Setup Child NVR Check Alive Procedure.)