User guide

DETEXI NVR 106 - 169
2) Setup PTZ Camera Recording Position
When alarm condition is detected a PTZ camera can move in a predefined position to record alarm video
and than return to any other position if necessary. Both positions should be configured.
1. To setup camera recording position under the Set camera in position enter Pan, Tilt, Zoom
parameters or select a preset position from Preset drop-down list (Fig 73).
2. If required to move camera to another position after the alarm video is recorded — check Reset
camera in position checkbox and enter Pan, Tilt, Zoom parameters or select a preset position from
Preset drop-down list below.
Fig 73. NVR Control Center — Tasks
(Configure Action — Record Camera — Setup PTZ Camera Recording Position.)
3) Check Camera Position with PTZ Control
1. To bring up a PTZ control — roll over the image and click on the button in the bottom right corner.
2. Getting PTZ values of the current position of the camera click on Get PTZ (Fig 74).
3. Change camera PTZ values —
9 Or enter Pan, Tilt, Zoom values.
9 Use Zoom in/Zoom out buttons on the right of Zoom field.
9 Click on Set PTZ to set camera in a configured position.
4. Use direction buttons and Home button on the left.