User guide

DETEXI NVR 109 - 169
3. Show Locally checkbox can be check to connect to the camera using local IP address and port
number (during configuration time only).
9 Show Locally checkbox is only visible if camera has both an internal and external
connections configured in the NVR Control Center — Cameras — Cameras Settings.
Fig 76. NVR Control Center — Tasks
(Configure Action — Move Camera — Define Camera.)
2) Setup PTZ Camera Move Position
When alarm condition is detected a PTZ camera can move in a predefined position, dwell a certain period
of time and than return to any other position if necessary. Both positions should be configured.
1. To setup camera recording position under the Set camera in position enter Pan, Tilt, Zoom
parameters or select a preset position from Preset drop-down list (Fig 77).
2. Enter Dwell time (s).
3. To move camera to another position after the alarm — check Reset camera in position checkbox
and enter Pan, Tilt, Zoom parameters or select a preset position from Preset drop-down list below
(optional).