User guide

DETEXI NVR 121 - 169
2) Start Tour
If Start Tour is configured — when the trigger event is met the camera starts touring from one pre-
configured position to the next in a predetermined order.
Start tour settings (Fig 88) —
1. Select a Start Tour radio button and camera's pre-defined tour from the active drop down list.
2. Setup Reset touring after (sec) time to reset camera position according to the normal schedule
when time expires (optional).
9 If reset time is configured the Uninterruptible tour action checkbox can be checked to
prevent an alarm tour from the interruption by a new alarm.
Other parameters —
3. Check Use local connection checkbox to connect to the camera using local IP address/port
number during Control Tour action (optional).
9 The checkbox is only visible if the camera has both an internal and external connections
configured in the NVR Control Center — Cameras — Cameras Settings.
4. Check Append to log checkbox to append action specific information to the existing log file each
time when Control Tour action is initiated (optional).
5. If necessary, enter a Start action in time (ms) — a delay between trigger condition detection and
action initialization.
Fig 88. NVR Control Center — Tasks
(Configure Action — Control Tour — Start Tour.)