User guide

DETEXI NVR 122 - 169
3) Stop Tour
If Stop Tour is configured — when the trigger event is met the camera stops in the current position until
new alarms/events occur.
Stop tour settings (Fig 89) —
1. Select Stop Tour on Camera radio button and camera’s pre-defined tour from the active drop down
list.
9 The Uninterruptible tour action checkbox can be checked to prevent a camera stop position
being changed by the new alarms/events before specified time expires.
Other parameters —
2. Check Use local connection checkbox to connect to the camera using local IP address/port number
during Control Tour action (optional).
9 The checkbox is only visible if the camera has both an internal and external connections
configured in the NVR Control Center — Cameras — Cameras Settings.
3. Check Append to log checkbox to append action specific information to the existing log file each time
when Control Tour action is initiated (optional).
4. If necessary, enter a Start action in time (ms) — a delay between trigger condition detection and
action initialization.
Fig 89. NVR Control Center — Tasks
(Configure Action — Control Tour — Stop Tour.)