User guide

DETEXI NVR 125 - 169
Configure Notification
Before any task could be assigned to a specific alarm/event it should be defined in the NVR. Each task is
a list of preconfigured actions and/or notifications that define what is to happen.
1. Network Client
Network Client notification launches the camera in alarm (when applicable) video stream along with
alarm information and alarm video access, to the defined DETEXI Client computer. Alternatively,
sends a user-defined message to be displayed on this computer, disregarding any alarm-specific
information.
When New — Notification — Network Client is selected the right panel will be populated with
configuration settings specific to the notification. To configure the notification:
1) Configure Network Client
When the trigger condition is met a Network Client notification alerts the operator on the defined DETEXI
Client computer by two different ways:
• If the Message can be changed automatically checkbox is checked — launches the camera in
alarm video stream along with alarm information and alarm video access (if alarm video recording
was configured in the task).
• If the Message can be changed automatically checkbox is unchecked — sends a user-defined
message to be displayed.
To configure the Network Client notification —
1. Setup an operator terminal Address and Port number (Fig 92).
2. Setup also Proxy Address and Proxy Port if necessary.
3. The Send always checkbox can be checked.
9 Multiple Network Client notifications can be created under one task.
9 If the Send always checkbox is checked the notification always initiates, if not — just in case
the checked notification failed.
9 At least one Send always checkbox must be checked in a task notifications.
4. Check the Priority alarm checkbox to add new alarm information on the top of the Alarms list
otherwise it will be appended to the bottom.
5. Enter a message to the Message text box.
6. Depending on the response you desire the
Message can be changed automatically checkbox can be
checked or unchecked.
7. Check Append to log checkbox to append notification specific information to the existing log file
each time when Network Client notification is initiated (optional).
8. If necessary, enter a Start action in time (ms) — a delay between trigger condition detection and
action initialization.