User guide

DETEXI NVR 141 - 169
2) Setup Recovery Procedure in a camera recording schedule
Another method to deal with IP-devices errors is to setup Recovery Procedure inside a camera recording
schedule. The Recovery Procedure fully describes how the Recorder will deal with the faulty camera.
1. In the NVR Control Center — Cameras select camera from the Cameras List and go to the
Recording — Schedule (Fig 105).
2. Select a schedule from the schedules list to update existing schedule or press Add button below
the list to create a new schedule.
Fig 105. NVR Control Center — Cameras — Recording — Schedule — Recovery
(Setup Recovery Procedure.)
1. Switch to the Recovery tab to setup a recovery procedure parameters:
9 Attempts in Recovery Procedure (RP)
9 Delay Between Attempts (in sec)
9 Delay Between RP (in sec)
2. Select predefined tasks for events you are going to track (in any combination)—
9 Task on First Error — (if assigned) the Recorder initiates the corresponding task
immediately on the video stream failure;
9 Task on Recovery Procedure Failure — (if assigned) task initiates if all the attempts of
Recovery Procedure have failed;
9 Task on Restore — (if assigned) task initiates in case the IP-device comes back online.