User guide

DETEXI NVR 142 - 169
3. Press Save button below the schedules list.
4. Repeat for the other schedules.
9 Setting up a Recovery Procedure for many cameras with complicated recording
schedules could be time consuming. To make it easier use the recovery settings
template.
3) The Recovery Procedure Recommended Settings
Attempts in Recovery Procedure (RP) — 5
Delay Between Attempts (in sec) — 30
Delay Between RP (in sec) — 600
Task on First Error — assigned
Task on Restore — assigned
According to the recommended settings the Recorder initiates the Task on First Error when the video
stream failure occurs. Than makes up to 5 attempts with 30 s interval to recover the stream. If any
of the attempts succeeds the Task on Restore will be initiated; if not — the next round of attempts to
connect to the faulty camera starts in 10min (600 s).
4) Create Template for Setting a Recovery Procedure
Setting up a Recovery Procedure for many cameras with complicated recording schedules could be time
consuming. To make it easier — a template enforcing particular settings in newly created schedules can be
created (Fig 106).
1. In the NVR Control Center go to the General — Advanced.
2. Under the Recorder Recovery Settings Template setup Recovery Procedure settings —
9 Attempts in Recovery Procedure
9 Delay Between Attempts
9 Delay Between RP (in sec)
3. Select predefined tasks for events you are going to track (in any combination)—
9 Task on First Error — the Recorder initiates the corresponding task immediately on the video
stream failure;
9 Task on Recovery Procedure Failure — task initiates if all the attempts of Recovery Procedure
have failed;
9 Task on Restore — task initiates in case the IP-device comes back online.
The Recovery Procedure settings from this template will be forced in to each newly created cameras
recording schedule and could be changed.