User guide

DETEXI NVR 10 - 169
3. Setup Health Monitoring Services — No Answer Task
To setup NVR health monitoring services you need to assign a task (action/notification that will be
executed in a case of failure) to each component you wish to monitor.
1. In the NVR Control Center — Monitor (Fig 1).
2. Press blue Health Monitor On/Off button in the bottom right corner — the system health
monitor
No answer task panel appears.
3. To assign a task to the system component (service) — select previously created task from the
drop-down list next to the component.
4. Assign a task to each system component.
Fig 1. NVR Control Center — Monitor — No Answer Task
(Setup system health monitoring tasks.)
9 Component failure if any will be detected within 3 minutes and the assigned task
will be executed.
9 System will check status only for the components with the checkbox checked.
9 For more information, refer to the NVR Events and Alarms section.