User guide

DETEXI NVR 149 - 169
3. Assign Input Alarm Task
IP-device Input Alarm executes task on hard motion detection, when an external motion detector is
connected to the IP-device input. If a camera supports external I/O, the Check Alarm (IO Listener)
service can monitor the status of the camera’s inputs. Input Alarm event is raised when an IP-device
defined input is in an active (non-normal) state. A separate event is raised for each IP-device input that has
this feature enabled.
1. In the NVR Control Center — Cameras (Fig 111).
2. Select camera to configure from the Cameras List and switch to the Recording — Schedule.
3. Select a schedule from the schedule list and switch to the Alarm tag below the list.
4. Select Input Ports from the Alarm on drop down list and specific input port from the Port drop down
list.
5. Check Active checkbox — the Execute task drop down list activates — select a predefined task
from the list.
6. Click Save button below the schedule list to save settings.
Fig 111. NVR Control Center — Recording — Schedule — Alarm
(Assign Input Alarm Task.)
9 The Input Alarm applies to hard motion sensing (triggered by an external motion
detector) only. For soft motion sensing (residing in the software) the IP-device
Soft Motion Alarm should be configured.