User guide

DETEXI NVR 59 - 169
Fig 34. DETEXI Client — Map Page
(Select Cameras.)
Configure Camera Tour
A tour enables PTZ camera to automatically move from one pre-configured position to the next in a
predetermined order. The viewing time between one position and the next is configurable. Different tours
also can be set up and activated during different times of the day.
1. Add Tour to PTZ Camera Configuration Settings
1. In the NVR Control Center — Cameras select a PTZ camera from the Cameras List and switch
to the Tour — Setup Tour — connection will be established (Fig 35).
9 This connection is temporary and allows the camera’s tour settings to be configured and
tested. If connection failed reconnect by clicking the Reconnect button.
2. Show Locally checkbox can be check to connect to the camera using local IP address and port
number (during configuration time only).
9 Show Locally checkbox is only visible if camera has both an internal and external
connections configured in the NVR Control Center — Cameras — Cameras Settings.
9 Press Add button below the tours list and enter Tour Name when asked — the name
appears in the list.