Operation Manual

1
20 Caravan - 11-06 - DET-0030-05E
N
Appliances
1
0
Filling the hot water source
with water:
Connect the vehicle to the external 240 V power supply and switch on the
240 V automatic circuit breaker.
Switch off the operating switch (Fig. 129). Indicator lamp (Fig. 129,1) in the
switch is not on.
Close drain cocks. To do this, close the caps (Fig. 130,1 and 2) by turning
them in a clockwise direction.
Set all the water taps to "Hot" and open them. The water pump is turned
on. The warm water pipes are filled with water.
Keep the taps open until the water flowing out of the taps has no bubbles
in it. This is the only way to ensure that the hot water source is full of water.
Close all water taps.
Emptying the hot water
source:
Set the 12 V main switch on the panel to "AUS" (off) (Power Pack SE).
Switch off the 240 V power supply on the 240 V automatic circuit breaker.
Remove the cap of the water tank.
Take out the stopper of the water tank.
Open all water taps and set to the central position.
Hang the shower handset up in the shower position.
Hold the water pump up until the water pipes are completely empty.
Open drain cocks of the hot water source. To do this turn the caps
(Fig. 130,1 and 2) in an anticlockwise direction.
Check whether the water is completely drained from the hot water source.
10.5 Cooker
Fig. 130 Drain cocks for hot water
source
Further information can be obtained from the separate instruction manual
"Hot water source".
Never let gas escape unburned due to danger of explosion.
Before using the cooker make sure that there is sufficient ventilation.
Open windows or the skylight.
Do not use gas cooker or gas oven for heating.
Always protect your hands with cooking gloves or potholders when han-
dling hot pots, pans and similar items. There is a risk of injury.