Operation Manual

Appliances
10
117Caravan - 14-09 - EN
10.2.9 Floor warming unit/warming unit for waste water tank (special
equipment)
The floor warming unit and waste water tank warming unit are connected to the
water circulation of the hot-water heater.
The regulator for the floor warming unit is installed on the right side of the vehicle,
on the floor at axle-height. The regulator for the waste water tank warming unit is
installed in the surroundings of the waste water tank inside the vehicle.
The heating output of the warming units for the floor and the waste water tank can
be adjusted by the continuously variable controls.
Switching on:
 Switch on the hot-water heater (see Section 10.2.5).
 Set the regulator (Fig. 111,1) to the desired flow level (max flow = arrows
(Fig. 111,2) in direction of lines).
Switching off:
 Turn the regulator (Fig. 111,1) until both arrows (Fig. 111,2) are at a right angle
to the heating lines.
 Switch off the hot-water heater if necessary (see Section 10.2.5).
Z For models with a floor warming unit and a warming unit for the waste water
tank, never drill holes in the floor or screw in any screws. Danger of damage to
a heating line and water leaking into the floor.
Z The floor warming unit and waste water tank warming unit only operate when
the hot-water heater is switched on.
Fig. 111 Regulator for floor warming unit/
warming unit for waste water
tank