Installation Instructions
Table Of Contents
- TABLE OF CONTENTS
- List of Figures
- 1 USERS OF THIS MANUAL
- 1.1. Purpose of this manual
- 1.2. End User
- 1.3. Training
- 1.4. Information
- 2 BlastWeb SYSTEM PRODUCT SAFETY
- 2.1. DetNet Safety Philosophy
- 2.2. User Safety
- 2.3. Transportation, Storage and Handling
- 2.4. Maintenance Schedule
- 2.5. Information in case of emergency
- 2.6. RF Repeater General Safety Warnings
- 2.7. Warning, Caution, and Note Statements
- 2.8. RF compliance - FCC (USA) and ICES (Canada)
- 2.9. DISCLAIMER
- 3 RF Repeater
- 3.1. Components
- 4 Installing RF Repeater
- 4.1. Mounting RF Repeater
- 4.2. Connecting Antennae
- 4.3. Backup Battery
- 4.4. Main Power
- 5 Solar Panel (Optional)
- 5.1. Mounting Solar panel to bracket
- 5.2. Connecting arm
- 5.3. Securing arm to a fixed pole
- 5.4. Adjusting Solar panel
- 6 Channel Setup
- 7 Troubleshooting
- 7.1. Replace main supply cable
- 7.2. Low Battery
- 7.3. PSU Card and RF Repeater Cards
UTM-00233 | Rev 3
Page 12 of 20 DetNet South Africa Copyright © 2019
Figure 5: Antennae connection points
Connect Bench Box Antenna in corresponding connector
Connect Base Station Antenna in corresponding connector
Place the antennas in such a way that there is a clear line of sight between the Base Station and Bench
Box RF antenna and the RF Repeaters corresponding antenna. (Also refer to figure 3)
Ensure that the antennas are mounted vertically and that their sides are not close to large metal objects.
Bench Box Antenna connection
Base Station Antenna connection