Installation Instructions
Table Of Contents
- TABLE OF CONTENTS
- List of Figures
- 1 USERS OF THIS MANUAL
- 1.1. Purpose of this manual
- 1.2. End User
- 1.3. Training
- 1.4. Information
- 2 BlastWeb SYSTEM PRODUCT SAFETY
- 2.1. DetNet Safety Philosophy
- 2.2. User Safety
- 2.3. Transportation, Storage and Handling
- 2.4. Maintenance Schedule
- 2.5. Information in case of emergency
- 2.6. RF Repeater General Safety Warnings
- 2.7. Warning, Caution, and Note Statements
- 2.8. RF compliance - FCC (USA) and ICES (Canada)
- 2.9. DISCLAIMER
- 3 RF Repeater
- 3.1. Components
- 4 Installing RF Repeater
- 4.1. Mounting RF Repeater
- 4.2. Connecting Antennae
- 4.3. Backup Battery
- 4.4. Main Power
- 5 Solar Panel (Optional)
- 5.1. Mounting Solar panel to bracket
- 5.2. Connecting arm
- 5.3. Securing arm to a fixed pole
- 5.4. Adjusting Solar panel
- 6 Channel Setup
- 7 Troubleshooting
- 7.1. Replace main supply cable
- 7.2. Low Battery
- 7.3. PSU Card and RF Repeater Cards
UTM-00233 | Rev 3
Page 15 of 20 DetNet South Africa Copyright © 2019
Install solar panel close to RF Repeater, keeping the cable between the repeater and solar panels as short as
possible
Loosen bolts on top adjustable bracket
Adjust bracket to fit width of solar panel
Tighten nuts to hold adjustable bracket in place
Slide solar panel into place along bracket rail
Secure bracket to the solar panel from the back of the solar panel using the eight screw provided
Adjustable bracket
Bracket rail
Adjustable bracket
Solar Panel
Solar Panel mounting screws