Installation Instructions
Table Of Contents
- TABLE OF CONTENTS
- List of Figures
- 1 USERS OF THIS MANUAL
- 1.1. Purpose of this manual
- 1.2. End User
- 1.3. Training
- 1.4. Information
- 2 BlastWeb SYSTEM PRODUCT SAFETY
- 2.1. DetNet Safety Philosophy
- 2.2. User Safety
- 2.3. Transportation, Storage and Handling
- 2.4. Maintenance Schedule
- 2.5. Information in case of emergency
- 2.6. RF Repeater General Safety Warnings
- 2.7. Warning, Caution, and Note Statements
- 2.8. RF compliance - FCC (USA) and ICES (Canada)
- 2.9. DISCLAIMER
- 3 RF Repeater
- 3.1. Components
- 4 Installing RF Repeater
- 4.1. Mounting RF Repeater
- 4.2. Connecting Antennae
- 4.3. Backup Battery
- 4.4. Main Power
- 5 Solar Panel (Optional)
- 5.1. Mounting Solar panel to bracket
- 5.2. Connecting arm
- 5.3. Securing arm to a fixed pole
- 5.4. Adjusting Solar panel
- 6 Channel Setup
- 7 Troubleshooting
- 7.1. Replace main supply cable
- 7.2. Low Battery
- 7.3. PSU Card and RF Repeater Cards
UTM-00233 | Rev 3
Page 20 of 20 DetNet South Africa Copyright © 2019
DS1 LED On, everything is working
LED Off, power Supply Unit faulty
DS2 LED On, Relay engaged
LED Off, Relay disengaged
DS3 LED On, 10V6 Supply Rail Good
LED Off, faulty return for repair
DS4 – LED On, 5V Supply Rail Good
LED Off, faulty return for repair
DS5 – LED On, 3V3 Supply Rail Good
LED Off, faulty return for repair
DS6 – LED On, charge source present
LED Off, not charging
DS1 – LED On, signal strength
LED Off, weak signal (no signal)
DS2 - LED On, Medium signal strength
LED Off, weak signal
DS3 – LED On, Good signal strength
LED Off, weak signal
DS4 – LED On, denotes channel select USA/RSA
LED Off, denotes channel select AUS
DS5 – LED On, denotes Base Station card
LED Off, denotes Bench Box Card
DS6 – LED On, everything is working
LED Flashing, error communicating
Refer to the label placed inside the door for reference to the RF Repeater Cards Status
LEDs