Specifications
Table Of Contents
- 1. USERS OF THIS MANUAL
- 2. SYSTEM PRODUCT SAFETY
- 3. Warning, Caution, and Note Statements
- 4. DigiShot® Plus Base Station
- 4.1. Components
- 5. Base Station Accessories
- 5.1. RF Antennae
- 6. Setup and Configuring DigiShot® Plus Base Station
- 6.1. Charging the DigiShot® Plus Base Station
- 6.2. Battery Errors
- 6.3. Power Base Station On
- 6.4. Power OFF DigiShot® Plus Base Station
- 6.5. Menu Navigation
- 7. System Settings
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 3. Under System Settings
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 9. Operation
- 9.1. Testing and Programming Detonators
- 9.2. Reprogramming Bench Box(es)
- 9.3. Blast RF Mode
- 9.4. Exit the blast sequence without firing (disarming)
- 9.5. Permanent Abort
- 9.6. Programming Errors before Arming
- 9.7. High Leakage during Arming
- 9.8. Last Det Check
- 9.9. Synchronisation Errors
- 10. Specifications
- 11. Troubleshooting Error Codes
- 12. Blast Layout
- 12.1. Unsynchronised Multiple Bench Box Blasting
- 12.2. Synchronised Multiple Bench Box Blasting
UTM-00232 | Rev 9
DetNet South Africa Copyright © 2018
Page 27 of 51
From any Channel Setup Menu, Select option 2 (Set Repeater Channel) and the RF Channel will
automatically be selected as 7 for a Bench Box
Digishot
®
plus bench boxes and digishot
®
plus base station must comply with the
following to ensure communication can be established between the base station and
bench boxes:
1. Use the same rf channel to enable communication with each other,
2. Have the same firmware version, and
3. Have the same encryption key.
Unique rf channels guarantee communication between bench boxes without outside
interference or cross-communication with bench boxes in surrounding areas.
Should multiple systems be deployed at a location (more than one base station), it is
essential to use different rf channels for each system. In such a setup it is
recommended that the channel separation between systems be greater than 4
channels, to mitigate interfgerence or cross-communication.
Select RF Channels between 1 – 7.
When connecting to a Base Station through a Repeater, the Bench will select Channel 7 and a
Base Station will select Channel 6.