Specifications
Table Of Contents
- 1. USERS OF THIS MANUAL
- 2. SYSTEM PRODUCT SAFETY
- 3. Warning, Caution, and Note Statements
- 4. DigiShot® Plus Base Station
- 4.1. Components
- 5. Base Station Accessories
- 5.1. RF Antennae
- 6. Setup and Configuring DigiShot® Plus Base Station
- 6.1. Charging the DigiShot® Plus Base Station
- 6.2. Battery Errors
- 6.3. Power Base Station On
- 6.4. Power OFF DigiShot® Plus Base Station
- 6.5. Menu Navigation
- 7. System Settings
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 3. Under System Settings
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 9. Operation
- 9.1. Testing and Programming Detonators
- 9.2. Reprogramming Bench Box(es)
- 9.3. Blast RF Mode
- 9.4. Exit the blast sequence without firing (disarming)
- 9.5. Permanent Abort
- 9.6. Programming Errors before Arming
- 9.7. High Leakage during Arming
- 9.8. Last Det Check
- 9.9. Synchronisation Errors
- 10. Specifications
- 11. Troubleshooting Error Codes
- 12. Blast Layout
- 12.1. Unsynchronised Multiple Bench Box Blasting
- 12.2. Synchronised Multiple Bench Box Blasting
UTM-00232 | Rev 9
DetNet South Africa Copyright © 2018
Page 51 of 51
• Connect up to four different benches with sequential timing across all connected Bench Boxes.
• Detonator timing is set as one bench, connected to up to four Bench Boxes.
• When splitting the bench onto multiple Bench Boxes, take into consideration:
o system limits,
o leakage
o and the load required to fire all Bench Boxes successfully.
• All Bench Boxes will receive the fire command at the same time.
• Should one Bench Box fail before the blast is initiated, the problematic Bench Box will send a
message to the Base Station and return to a rearming state. The Base Station will stop the entire
blast.
• The user may attempt re-blasting after improving the communication strength to the Bench Boxes.
It is recommended that RF communication strength be greater than 75%, with the minimum of 60%, for all
Bench Boxes when attempting a synchronised blast – this figure is displayed on the Base Station.